Last night we had snow, today got into the high 50's Nice and warm out side, So I decided to go take one sheet of plywood off to take a peek... well once I got started it was too fun to stop! well until it started getting cold again! I started by removing the cheesy trim they installed over the plywood... Ha.. only to find there was about an inch gap between the two pieces of ply wood... Now I have been reading everyone else's builds and post, so I wasn't expecting perfection... but a little surprised....
I wasn't too surprised to find the rust on the metal beams, but was a little surprised by the poor workmanship such as screws missing the beams, gaps and holes,
One more complaint, the dealer offered for $300 ( I think.. I don't want too look now) to insulate the ceiling and put a ceiling in... they used cheap paneling, but that's ok, I was going to cover with something different anyway, The insulation looks hit and miss....
Now on a good note, I pulled up the floor plywood in the V nose to take a look, and they did under coat the frame and bottom of the Plywood flooring