by scopeaddict » Thu Aug 17, 2006 11:17 pm
O.K. so now im seriusly confused, and my heads spinning,
the aussies are too strict, and everybodys got an opinion,
i did learn im doing a "composite" tounge, so i got somewhere,
i just wish someone would give me some safe thicknesses, and lengths to
buy and weld up,
i was going to go with 2X2x1/8 on my angle composit pieces and 2X3X1/8
on the tounge,
so that being said,
can i go out to 4 foot and be safe,
and how far back into the frame should i go??
thanks, and remember im brain-damaged so sometimes i "need"
crayons,
not said for pity,--just a fact of my life,
sh** just doesnt click -in like it used to,
johnp
Deep Sky imaging and need a warm place to curl up,
Have 4-angry squirrels powering a Jeep YJ,
will travel, eventualy,,grin