Terry's TTT Garageable Standy Build modifications

[terryjones1]

Shown below is a photo of the Fantastic Vent that has been installed on the front of the trailer. It has been masked off for application of adhesive/sealant.



Shown below is a photo of the two right side windows that have been installed on the trailer.



Next, I will install the left side windows.
Then, I will install the door, the outside electrical, and the Air Conditioneer.


.

[aggie79]

Looking really nice Terry! Your TTT is almost campable.

[terryjones1]

Shown below is a photo of the right side and front of the trailer with clearance lights, porch light, windows, Fantastic Vent, and door installed.



Shown below is a photo of the right side and rear of of the trailer.



Shown below is a photo of the left side of the trailer showing input power and TV connectors.



Shown below is a photo of the left side and rear of the trailer showing Tail lights and license plate light. The photo also, shows the Air Conditioneer platform.



Next, I will work on the inside door trim, and Air Conditioneer installation.

Then, I will install bed platform, cut & install the mattress, plan & install water system, order seat cusions, and do touchup painting.


.

[mezmo]

Lookin' Good!

Cheers,
Norm/mezmo

[b.bodemer]

Looks wonderful!!!!!
Barb

[stugpanzer]

Excellent build! Do you have any plans to weigh the finished Trailer? i would be very interested in knowing the completed weight of your creation!

[terryjones1]

When I finish the trailer, I will weigh it.

[IndyTom]

That is one good looking trailer. Well done!

Tom

[campmaster-k]

Great job Terry - looking great.

[WhitneyK]

The photo also, shows the Air Conditioneer platform.

I'm glad you specified what that was for. There for a minute I thought you were going to start selling hot dogs from that window.

[terryjones1]

Shown below is a photo of the trial installation of the Air Conditioneer.
It has been given one coat of paint to match the trailer.
The 1" x 1" x 1/8" (primed grey) angle aluminum is used to attach the Air Conditioneer to the rear wall.
The Air Conditioneer rests on the shelf that I had previously installed.
Another coat of paint will be given after final installation.
I tried the Air Conditioneer.
It works in both heat and cold mode.



Next, I will install interior trim for the Air Conditioneer.


.

[terryjones1]

Shown below is a photo of the Air Conditioner.



Shown below is a photo of the rear bed platform.
Because of the weight, The bed platform is built in two sections.

[terryjones1]

Shown below is a photo of the rear bed.
Ech half of the bed measures 38" x 64" x 6".
Each half will get a cloth cover.
I will place the 38" sides together to make up a 76" x 64" x 6" bed.



The front dinette cusions are on order.
I should receive them next week.




.

[terryjones1]

Shown below is a photo of the rear tire carrier with the tire mounted on the carrier.
I have a tire cover on order.



Some of the touchup paint did not match.
I will be giving the trailer one more exterior coat.

After the bed, dinette seats, and repaint, I will pretty much be finished, except for the water system, which I will do later.


.

[terryjones1]

Shown below is a photo of the rear bed mattress.
It measures 76" x 64' x 6".
Each section uses a standard bed sheet for a cover.
I used "Iron on" Velcro to fasten everything together
To the left, is the head of the bed; and, of course, to the right, is the foot of the bed.



The front seats should be ready this coming week.


.