by Chip » Tue Aug 31, 2004 2:24 pm
Ok ya'll just had to get me thinking again,,,ya'll just had to do it,,,OK this aint my fault,,,so here goes,,,
build a tear with a 5'x10'base,,,on top of this (hull) build a 4'x4'x10' tear drop,,,the front bottom rounded part of the hull blends into the 4'x10' top chamber,,rear hatch opens down to approx 20' above the actual bottom of the tear/boat,,pull the motor mount a bit forward to fully enclose the motorwith hatch either open or closed,,,put lots of windows in the front,,open the doors,,instead of a front bulkhead its a dash/console with a steering wheel,,another galley requirement ,,where in the hairy do I mount a 5 gal gas tank,,,ohhh and battery,,,now figure out the balance point,,,remember the 9.9 hp motor hung off the rear
barge bottom,,teardrop top sleeping for two,,,guess ya got to beach tha thing to cook,,,,oh and make it so it slides onto a 5x10 Lowes trailer,,,,,,,dang my head hurts,,,if I ever figure out how to use and post cadd ya'll are definately in trouble,,,,
chip
Living large,,,travling small !!!
54"x9'4" tear
4'x8' tear
Serro Scotty rebuild(in progress)