Hello folks,
I thought I would share my experience with insulation on the floor. Following the generic Benroy plans, I used 1 1/4" deck screws and fender washers.
I had a lot of trouble with break through. Now, I have a 1/2" floor. People with 3/4 inch floors might have no trouble at all with 1 1/4 inch screws. Or maybe it is just that some people have a lighter 'trigger' finger <G>
For my part, I found it much easier to back the screws out and use 1" screws instead--worked much better. If you are using 1/2 inch ply for your floor, you might consider moving to 1' screws if that is the way you attach to the floor.
Ciao,
Jim
Teardrops n Tiny Travel Trailersor t n ttt for short (tnttt.com) |
Insulating the floor--advice---
7 posts
• Page 1 of 1
Insulating the floor--advice---
by kayakrguy » Tue Jun 27, 2006 1:16 pm
A disposition to preserve, and an ability to improve, taken together, would be my standard of a statesman...
But what is liberty without wisdom, and without virtue? It is the greatest of all possible evils; for it is folly, vice, and madness, without tuition or restraint.
Edmund Burke
But what is liberty without wisdom, and without virtue? It is the greatest of all possible evils; for it is folly, vice, and madness, without tuition or restraint.
Edmund Burke
-
kayakrguy - Lifetime member
- Posts: 917
- Images: 195
- Joined: Sun Feb 05, 2006 8:26 pm
- Location: Jersey Shore
as a body piercer, I would think that would have some appeal...
