On a side note- I'm going to build this trailer using engineered wood products - plywood mostly. My goal is to not use any dimensional lumber at all- something I've become proficient at after 25 years building cabinets.
Floor deck down...progress
6 posts
• Page 1 of 1
Floor deck down...progress
by Mark McD » Thu Jan 22, 2009 7:30 pm
Got the floor decked. Used 3/4 cdx. Coated the underside and fastened with self tapping screws. The next step is to roll the trailer outside the shop so I can draw a full size template of the sides- hopefully tommorow.We finally had a heat wave- 32 degrees! ,so it's been easier to heat the shop. Woo-hoo! Then I'll start framing my sides. Once I have the sides framed I'll pull the trailer back in, pull the wheels off and level the trailer for the build!
On a side note- I'm going to build this trailer using engineered wood products - plywood mostly. My goal is to not use any dimensional lumber at all- something I've become proficient at after 25 years building cabinets.
On a side note- I'm going to build this trailer using engineered wood products - plywood mostly. My goal is to not use any dimensional lumber at all- something I've become proficient at after 25 years building cabinets.
Last edited by Mark McD on Sun Jan 25, 2009 3:59 pm, edited 1 time in total.
I like turtles
Mark
I don't feel tardy
Mark
I don't feel tardy
-
Mark McD - The 300 Club
- Posts: 427
- Images: 63
- Joined: Sat Jan 19, 2008 12:53 am
- Location: Northeast Ohio
The upside is, the plan can change as we go!
