I have been doing work slowly over the last couple of weeks. I finished the floor framing, and started on the profile for the walls.
First had to extend the walls. Used the router to create a lap joint and glued the pieces together. This gives me a wall blank that is 9 ft. 6 inches long. I only need it to be 9 ft 3 inches for my profile.
![Image](http://www.hudsonhawk.net/trl/images/trailer45.jpg)
nothing like a bag of old concrete to use as a press.
![Image](http://www.hudsonhawk.net/trl/images/trailer46.jpg)
After that all dried, I marked out the profile and modified my design slightly.
I cut out the basic profile today. Need to still cut out the door, wheel well and the hatch.
![Image](http://www.hudsonhawk.net/trl/images/trailer47.jpg)
Went shopping for electrical and building supplies for the trailer today. While at Home Depot I found these hinges.
![Image](http://www.hudsonhawk.net/trl/images/trailer48.jpg)
They are enamled gate hinges. $6 a piece including screws. Better yet they are similar enough to the design on the Wrangler to look good with it.