what do you use for a teardrop assemble table

[Ron Dickey]

Here is one Mike made in 2005

I use what fits and that is saw horses and plywood.

What do you use?

[planovet]

I used 2 sawhorses and a piece of plywood reinforced with some 2x4s.

[jonw]

I made a 4x8 platform using 2x4s and a sheet of cheap 3/4 plywood on locking caster wheels so I could roll it in and out as I worked on it.

Worked like a champ

[Rlowell]

I used saw horses and then the trailer base until the walls went up. Then back to the saw horses.

Rod

[asianflava]

Don't need no stinkin' table. I used the garage floor (and knee pads).

[Jdw2717]

Numbers 2,5,8 and 9 are what I used for mine.

[RandyG]

I use an old ammo can in the back and a tool chest in the front. I keep the trailer on that to keep my saw horses handy.

[len19070]

I use what I call "Bingo Tables". I have about 6 of them, 30X96" and I have 2 sets of "Leg extenders" I made to make the table 30", 36" or 42" high.

Depending on what I'm doing. (And how much leaning over bothers my Back)



Happy Trails

Len

[bobhenry]

DUH ! Dummy me, I used the floor of the trailer I was building .

[planovet]

Don't need no stinkin' table. I used the garage floor (and knee pads).

I used my garage floor also when my table was not quite big enough

[Ron Dickey]

Don't need no stinkin' table. I used the garage floor (and knee pads).

I used my garage floor also when my table was not quite big enough

putting plastic on the floor makes sense

[asianflava]

I was about to bond the faces to the wall frames with epoxy. The plastic is really slippery when it is doubled up.

[planovet]

Yep, I was gluing my frame together and did not want to get glue on the floor. Once the glue dried, any that squeezed out peeled away easily from the plastic.

[Mary C]

well, this is what I use .....a twenty something picnic table...even as I speak it is in use...












Mary C.