Ok, work has begun on my Moto-Tear. I have the HF frame painted, together, and basically ready to go (see the album for a few pics). Went together pretty well with the new tongue et. al. I added 4 Fulton stabilizers and drilled them for safety clips (don't want anything dropping down in motion behind the bike).
I re-packed the HF bearings, which is highly recommended as the hubs were very dirty inside, and the grease is questionable. And, as might be expected somewhere along the line, one of the grease zirks is missing (the only missing piece I found). So my question is, are the grease zirks on the HF hubs metric or standard?
thx
~dave