I've done the second coat on the bottom and the doors painted. I had to wait a couple of rainy days for
the latex to dry.( stop being sticky ) The doors stuck to the hardboard used for a painting table on top
of my table saw. While I waited I wired the running lights and started the interior lighting.
Working with no plan I stumbled. the door jamb I glued directly to the foam is not deep enough to add
a gasket. I need to either route it off and add another inside or shim out the door an 1/8th...
dry fit of door and window.
![121499](http://tnttt.com/gallery/image.php?mode=thumbnail&image_id=121499)
I measured and drew a straight line...
I didn't check my masking!!!
![121500](http://tnttt.com/gallery/image.php?mode=thumbnail&image_id=121500)
door light on handle side
![121501](http://tnttt.com/gallery/image.php?mode=thumbnail&image_id=121501)
I could wait no longer!
First hook up test, brakes
![121502](http://tnttt.com/gallery/image.php?mode=thumbnail&image_id=121502)
Side lights
![121503](http://tnttt.com/gallery/image.php?mode=thumbnail&image_id=121503)
Camper is about 2 inches above the car roof.
It looks huge with the top down on the car.
![121504](http://tnttt.com/gallery/image.php?mode=thumbnail&image_id=121504)
The other perspective...
![121505](http://tnttt.com/gallery/image.php?mode=thumbnail&image_id=121505)
The car is charging the batteries through a solar controller.
13.47V at idle on my HF VOM.
Also today, I painted the inside of the doors first coat. I stopped
at Lowes and got a sample of black paint to touch up my drips on
the frame.
I'm thinking of getting a pinstripe tape, black, to clean up the 2 tone
junction. Will it stick on this canvas and latex very well or should I
just paint a stripe?
![Thinking :thinking:](./images/smilies/econ_thinking.gif)