by working on it » Sun Aug 10, 2014 8:01 pm
For the past two years, I've been explaining why and how I put my A/C inside the galley, and not on a slide-out, or (as shown in this thread) completely outside the trailer. Shadow Catcher and Bobhenry show theirs sitting on the ground, and mikerueve shows his on an outdoor stand. My question is this: what prevents the "normally located inside the abode" electrical/electronic controls, on the face of the windowshaker, from damage if a sudden downpour saturates them. To my best knowledge, at least on my home units, they are not potted/waterproofed against the elements. Looks like Shadow Catcher built a cover over that area (for protection?), but did you other guys do something similar? And, do you have spare hoses handy, in case of inadvertent damage or mis-adventure (my park power source was unplugged by neighboring campers, so could the hoses) by passersby? My system was hard to perfect; the system shown here looks simpler, and possibly more a universal solution than mine, so what drawbacks (if any) did you have to overcome?
2013 HHRv "squareback/squaredrop", rugged, 4x8 TTT, 2225 lbs- *3500 lb Dexter EZ-Lube braked axle, 3000 lb.springs, active-progressive bumpstop suspension
- *27 x 8.5-14LT AT tires (x 3) *Weight Distribution system for single-beam tongue
- *100% LED's & GFCI outlets, 3x fans, AM/FM/CD/Aux. *A/C & heat, Optima AGM, inverter & charger(s)
- *extended-run, on-board, 2500w generator *Coleman dual-fuel stove & lantern, Ikea grill, vintage skillet
- *zinc/stainless front & side racks *98"L x 6" diameter rod & reel carrier tube on roof


