by GPW » Mon May 18, 2015 7:07 am
So we got in the nose of the FS and sprayed the bleach cleaner (household cleaner with bleach) on the whole affected area, then scrubbed it all with an old stiff brush ... wiped everything down with paper towels to remove as much surface moisture and gunk as we could , then put Newton clamps (bricks ) on the soft ply , and rigged a fan to blow on that all day and night ...
Results this morning were, much reduced mold (some staining) , the laminations are flat again , and everything’s ready for some glue injection (syringe) , then bricks and fan again ....
- Attachments
-

- DSCF0075.JPG (176.37 KiB) Viewed 1671 times
-

- DSCF0076.JPG (182.64 KiB) Viewed 1671 times
There’s no place like Foam !