dales133 wrote:Both those sika products would stick your pannels on quite happily without the need for mechanical fastners
Overnuts wrote:Hi, I have 2 composite panels :
one spare ( 1m x 2m ) raw/flat
and another one already prepared (in 2015) to make a front face (the yellow on the picture)
I can fold the spare one to make the green part, which will be permanently attached.
And using a hurrican hinge on top of box, make the yellow rotating to close.
What do you think about this ?
Overnuts wrote:If doing so, I will need to glue on " L " aluminium framing inside to be sure panel will not crack on fold line, Ok, for 90°, "L" will be fine,
but how will you do it for 135° angle ? what about gluing a pipe ?
(I have a 3d printer for PLA)
Return to Newbies, Introduce yourselves
Users browsing this forum: No registered users and 4 guests