Profile notch?

[Diemjoe]

Thanks for the explanation. I am finally starting to get my head around the notch. It is good to know the factors behind the sizing so I can see I can adjust it to my situation.

[dales133]

A rule of thumb is for the clearance for the seal/weatherstripping is to be about 1/4 to 2/3 of the thickness of the seal. My "notch" is 1/4". On top of the galley sidewall I added aluminum trim that was 1/16". I also added .040 aluminum on the underside of the hatch skin that overhangs the sidewall. This left a clearance a little less than 3/16" inch. The D-shaped seal I used was 1/4" tall, so when the hatch is closed it "squishes" a little more than 1/16" (or 1/4 if the 1/4" seal height.)

Im doing almost exactly the same thing with the aluminium on the wall edge and under the hatch skin but the only rabbet bit i have is 10mm and my seal is also 10mm.
Ill do a mock up for you to get your thoughts.
Regards dale

[dales133]

Ok heres some pics of the componants ive found to make the seal/edge.
I may need to change the underside if the hatch to .5 mm aluminium as the piece ive got tbere now may restrict coverage by the edge mold

uploadfromtaptalk1441505488836.jpg (31.96 KiB) Viewed 425 times

uploadfromtaptalk1441505475315.jpg (30.08 KiB) Viewed 425 times

uploadfromtaptalk1441505426735.jpg (40.89 KiB) Viewed 425 times