A few more things just to tidy up the end of my build. Haven't posted in a while, and A LOT has happened since then.
Got the 1/8 luan installed on the bottom side of the hatch. With lights.

Also, we finally have the 2 bunks installed permanently. 2 pieces of foam from Joann fabrics for the mattresses, a closet road so the top kid doesn't fall off, and some twin sheet (for now) wrapped around the foam to act as a bottom sheet.


Jumping around here a bit, but after a couple short camping trip, it was decided that we really needed a side table. So, I made one out 1/2 birch I had laying around, 1/2 and 3/4 conduit, and spring clamps to hold the leg wihle traveling. OH..and a box coduit inlet (not sure of the proper electrical name) to screw the leg into.I had a long enought piece of table bracket that I was able to make a side and an end bracket for the table. The mating pieces are mounted on the side (preferred) or the back over the left lower cabinet (if it's raining). The side is preferred so I don't have to take the table down to close the hatch at night.

A bit of team spirit I acquired. Works nicely to hold my propane while cooking.

Paper towels were getting in the way

That's mostly it for now. We took a 16 day trip out to Kansas, circled back round through St Louis and came home.. BUT That's another post of photos entirely. I will update later.