Hatch gasket

[fourbtgait]

Has anyone tried/used this gasket from Trimlock for a rear hatch?
1/4" ply inserts into it negating the need for alum angle trim.
Good, bad review?

[Redneck Teepee]

Yes. This is how my rear hatch is trimmed and sealed. So far no issues with leaks, seems to do the job even when I wash/rinse it with a fanning pattern from a spray nozzle on the hose.
Here's the catalog link

http://www.trimlok.com/prod/Catalog-700_179.aspx
Click on hatch seal

[fourbtgait]

Thank you. Yes, I found it in the Trim Loc catalogue. I thought it would provide a nice clean edge instead of the typical bent angle.
Glad to hear it works well for you. Is it very still in compression?

[vegask]

Yes. This is how my rear hatch is trimmed and sealed. So far no issues with leaks, seems to do the job even when I wash/rinse it with a fanning pattern from a spray nozzle on the hose.
Here's the catalog link

http://www.trimlok.com/prod/Catalog-700_179.aspx
Click on hatch seal

Do you have any pics of how you set that up?

[fourbtgait]

It is easy to set up. I went ahead and ordered it. Closed it flattens to 3/4-7/8" wide. I laminated a rain channel also for it to but against.
It will look clean I think.