Hi all, I'm hoping for some advice.
I installed new trailer lights. The original ones I installed had a short (I think) on the left side. They had been working and I'm not sure what happened but the left turn and break signal wouldn't go on but the running light remained on even after I turned off the tow vehicle.
So I took those off and got a new kit.
The new lights aren't working at all. I have a four pin flat connector. Because I built the teardrop frame wider and longer than the trailer frame the lights have to be installed on to the wood. To ground the lights I ran a ground wire from each light to the ground connection on the trailer tongue.
Do you have any advice or ideas about what is going on?
Many thanks,
Mariann