I inadvertently overlapped some fresh epoxy and fresh urethane over about a 2 inch strip.
if the hair drier doesn't work, time to get sanding!... at least it is only about 1-2 sqft...
S. Heisley wrote:I understand that some epoxy will out-gas while curing. If that happens, plan on cleaning everything off, sanding it a bit and reapplying.
JamesDixonLR wrote:Question: was the urethane over epoxy to keep UV off the epoxy? In researching my project, I read that epoxy breaks down under UV. At the same time, epoxy has good qualities so maybe you want it and want a way to protect it.
JamesDixonLR wrote:Question: was the urethane over epoxy to keep UV off the epoxy? In researching my project, I read that epoxy breaks down under UV. At the same time, epoxy has good qualities so maybe you want it and want a way to protect it.
Users browsing this forum: No registered users and 8 guests