It's been a little while since I posted and have done quite a bit...
Got my sink and water tanks plumbed. Having running water is SO COOL!
Did some work on the interior lights:
Got the rear hatch window cut and installed
Cut out one of my doors and it's matching window:
Spent some time fitting the doors and finding out that my hinge placement was off by about 1/2" (the t molding interfered with wall). Good thing I didn't drill all the way through the wall when I did my test fit. This means I can move the holes and nobody will know (well except me and I guess you'll know too since you're reading this):
I also worked on the T molding a bit... I did the annealing trick with the candle soot and it worked great:
After looking at how my rear window turned out, I decided to add some black paint around the window seats just so you didn't see the raw plywood edge through the clear polycarb.
I also got the first sheet of aluminum on the rear hatch and even started bending up the trim. Seeing the trim wrap around the curves is so satisfying:
And finally, I cut out the window seam covers out of black ABS. They will cover the joint between the polycarb and the aluminum. They are a little thicker than I initially wanted, but I wanted to be sure to have plenty of space to add caulking.