Jeremy757 wrote:I got a new router and I have never used one before. What different kind of bits will I need? Do I need a special router bit to cut the aluminum skin?
Also advice on attaching walls to trailer would be great.
I plan on sitting the walls on top of the lip of the angle iron
Then drilling and counter sinking screws through the wall into the side of my subfloor.
“Glued and screwed”
Then i was going to setup some temporary spars to hold the 2 sides together.
I’m using 3/4” birch for the walls.
I’m a complete newbie at wood working so I’m open to all advice.
Users browsing this forum: No registered users and 20 guests