- image.jpeg (633.56 KiB) Viewed 1193 times
- image.jpeg (633.56 KiB) Viewed 1193 times
Skin installation order ?
2 posts
• Page 1 of 1
Skin installation order ?
by joe hancock » Wed Apr 24, 2019 6:53 pm
Building 1st square drop , 5x8 NT trailer , using 1x1 steel tubing for the frame ( will try & load pics) 1/4 inch inside /out with 1 in blue foam insulation, going to wire lights everywhere , not sure how on roof , 1/4 with fiberglass or 1/2 & paint , so my question is which 1st ? Also any suggestions on adhering 1/4 in to steel studs ? Thnxs
- Attachments
-
- image.jpeg (52.09 KiB) Viewed 1189 times
- joe hancock
- Teardrop Inspector
- Posts: 1
- Joined: Wed Apr 24, 2019 4:12 pm
Re: Skin installation order ?
by twisted lines » Sat May 04, 2019 11:53 am
I finally glued my first section after checking lots of product's 
I am adding 1 more inch of foam board inside to ez with the wiring something to think about.
I am adding 1 more inch of foam board inside to ez with the wiring something to think about.
Racking up; And Rapin foam
-
twisted lines - 1000 Club
- Posts: 1243
- Images: 2
- Joined: Wed Oct 10, 2018 4:37 am
- Location: Jefferson