Atomic77 wrote:I basically sprayed to the center nice and wet and then went around to the other side to pick it back up. Then I sanded and buffed it. Yours will be much easier. I also adjusted the fan on the gun to a straighter spray in order to reach. Once you get to laying it down you'll see what I mean.OP827 wrote:Atomic77 wrote:It was tough on mine. 9' tall and 7.5' wide. I did it off of laders
Sent from my SM-N950U using Tapatalk
Your paint job was obviously much more challenging. My roof is only 2-3 feet high and not as wide as yours. Did you put ladders over the roof to have support and to reach the middle, how did you sequence the spraying to help with wet edge, or you just put down enough material and then cut and buff?
Sent from my SM-N950U using Tapatalk
So you "pushed to the middle and then jumped to the other side and "pulled" the coating towards yourself? Did you go the full length of the roof? I am afraid to rub the side of the roof and damage the clear in that case. I know what you mean about changing the fan from flat to round, the gun starts to shot much longer distance, but should be moving really fast to avoid runs. Thanks for the pointers Michael.