Moderator: eaglesdare
Pmullen503 wrote:A hot iron over a wet cloth will steam out that writing. So much so that you may not need to use filler.
JazzVinyl wrote:Ripped down pressure treated 2x4's to be the 1x2 floor spacers:
.
ghcoe wrote:Floor spacers are upside down. The tapper is designed so that it clears the drip edge, but has full support of the trailer frame.
JazzVinyl wrote:George, do you think leaving the last one off would be okay?
Also, George...my spacers are thicker then the 1x2's you specified. Might have to go with a different drip edge (like on your house) to account for thicker spacers. Think that would work? Or should I fall back to the specified 1x2 spacers?
Cheers...
ghcoe wrote:If there is not too much overhang it should be ok. Especially since you are making a box frame for the floor. Which if you put a sheet of foam in you would insulate the floor more. Just a suggestion.
Spacers probably would be fine. My spacers show some as well. I don't really notice since I painted the spacers the same color as the trailer. No biggie.
JazzVinyl wrote:
And I wonder if you could post some closer photos of the drywall item you are using as the drip edge?
Do you "drip edge" front and back, too?
Appreciate!
Users browsing this forum: No registered users and 14 guests