Intro and title, “motobox that my wife would camp in”

[hankaye]

BigDave_185, Howdy;

buytal tape, works fine ...lasts a long time.
Handling tip, if it's warm where/when you want to install the buytal tape
put it in the freezer for a while first, otherwise it gets to soft n saggy.

hank

[BigDave_185]

How warm are you talking.? Outside air temp is about 35 today but the garage I keep at 65. Also need to sheet walls today before i get windows back in


Sent from my iPhone using Tapatalk

[hankaye]

BigDave_185, Howdy;

, Just another one of those warm winter days in Utah eh?

Throw it outdoors, bring it in when ready to apply it.
Generally if your comfortable in a T-shirt it can use some cooling down.
Just makes it easier to handle is all.

hank

[BigDave_185]

Copy that

Any once have suggestions for transfer it the cut outer wall of the window to the sheeting I just put back up on the inside?


Sent from my iPhone using Tapatalk

[BigDave_185]

Sent from my iPhone using Tapatalk

[pchast]

I think my approach would be to lightly attach the inner sheathing and
scribe it from the outside before window installation...

[BigDave_185]

So I just re read my last post. Oh boy th at was bad!!!

So I took the vibe saw and cut it out. Then made my hole bigger


Sent from my iPhone using Tapatalk

[BigDave_185]

And he passenger side is re sheeted,



Sent from my iPhone using Tapatalk

[BigDave_185]

Well folks I made a mistake, got another window in and managed to put a 3/4 screw into the frame and..... screwed through the window


But.... I might just tap it with the tig and see if I can close the holes up. Oops


Sent from my iPhone using Tapatalk

[featherliteCT1]

Or maybe just fill hole with caulk and hide with black touch up paint?

[McDave]

Hey Big Dave,
S**t happens sometimes... a lot. No biggy. So I'm not sure of the camera angle there, but I think I see the drain slots at the top? IDK, but check that out. Drain at top would not be the preferred orientation. Slots made to let water out, not in.

McDave

[dirtsailor2003]

Black caulk and call it good! As McDave said if those are the weep holes they need to go facing down or you’ll get water inside.


Sent from my iPad using Tapatalk

[BigDave_185]

Well... testing out my old epoxy from a previous life



It’s old enough I had better check the chemical mix before I pour it on my trailer floor. Bottoms up as it goes. Hopefully in 12 hrs this cup is as hard as a rock.


Sent from my iPhone using Tapatalk

[BigDave_185]

As of last night at 11pm. The cup was hot enough I couldn’t hold it, the rolled out sample was still wet.

Fast forward to today at 7:00 the cup was hard as a rock




Sent from my iPhone using Tapatalk

[BigDave_185]

Now to locate some primer and I’ll have a self leveling epoxy that is bullet proof.




Sent from my iPhone using Tapatalk