Yes, indeed, another day of progress! Upper section of walls glued in and 3 sides with straight tops!
Front yet to be cut straight. Tomorrow project! So what I did was welded in the center post long, stringed it and cut that post in place hoping it would work out right in this phase... and it did!
So happy about that! I strung it again to cut the XPS and tolerance was spot on! Love it when a plan comes together.
With the uppers in place, I could now glue in the sides. Mostly this was done by using Gorilla glue on the edges. I'm used to this product and it just works well in so many conditions.
The wife came out to check on progress and busted my balls with "You sure you'll fit up there? Looks kinda tight.."
Walked her through the spacing now that you can really see what it is.
Any thoughts about this folks?
Think I may do a mockup and show hers better what I'm seeing.
Yes, I'm hesitating closing in the back.. Been debating how I wish to do this part all along..
Think I'm closing in on a thought here and it may just be the rear to be removable. If you recall from the design.
I keep looking at this and see a bit more steel welding coming into play to hold the weight of possible water & propane. If I make it as a unit, to be hung on the back, the truck could be used otherwise as well. Just kicking this around in my mind, but need to decide fairly soon...