I finally got my #9 Torflex axle from Dexter, and spent the weekend installing it on my half-built tear drop (it's built on norther tools 5x10 trailer, I I had it siting on jacks until this point).
Once I got it installed, I noticed however that both wheels angle outwards from the center axis (toe-out) quite a bit (so much so, that I was able to notice it by just looking at it).
Quick measurement confirmed my observation as well.
I'm guessing this is not expected? Is there a way to adjust the axle somehow?
I also see there is some amount of positive camber, that might be because the trailer is not finished, so probably lighter than it will be (and definitely lighter than 2000lb the axle is rated for).