needed: 1/2" thick, 1-1/2" tongue and groove

[tac422]

Hi Folks,
I'm looking for some 1-1/2" wide Tongue and groove, 1/2" thick to repair some damage on a 1932 build (not a teardrop) I'm working on.
Type of wood doesn't matter much.
Any thoughts or leads appreciated.
Tac
(The Big Pink)

[halfdome, Danny]

You could make your own or cut down some pre made and remake the tongue or groove.
Danny

[tac422]

Making my own is probably what I'll do.
Looking around the interwebs shows they do make it. Just have to order large qty and pay shipping

[swoody126]

if you have the ability to mill your 1/2" material AND have a small router table set up you can make your own out of any wood you choose

Amazon sells a router bit set for cutting various width's of slots up to 1/2" deep

w/ the combination offered you can pick your poison

BON CHANCE

sw