Plastic T molding

[oklahomajewel]

plastic T molding on ebay

I was looking to order by aluminum T molding for the doors, my Jewel Box is not going to be covered in aluminum though.

I just by chance did a google too, then an ebay search and found several auctions for a 3/4" T molding used on arcade games and shelving apparently. I found it in black, white, gray, red, etc.

Sorry I didn't get the link but has there been any cussing or discussing about it?

Julie

[madjack]

my misgivings would start with the fact that the center leg (and the rest for that matter) would not lend itself to attachment in the same manner that AL T would...it would be prone to cracking and would not be rigid enough for a proper seal....and then the whole UV thing to boot...I would say go with the AL...but then I am predjudiced towards the AL...
madjack

[Paw_Paw_Drew]

I think the T-Molding you are talking about is meant to go in a groove arounf the edge of a table. I don't think it would work for reasons already stated unless you want to put it on a counter edge in your galley.

[JunkMan]

I've got a couple of rolls of that, and I don't see how you could make it work. I can send you a piece if you want to try it though.

[Ira]

Could I use that on the tops of my doors? Will it bend that way?