My gut says that just sealing up the wire hole and putting sealant on the screw threads should be enough, but I want to run it by you all first.
Teardrops n Tiny Travel Trailersor t n ttt for short (tnttt.com) |
Question on Sealing Tail Lights
4 posts
• Page 1 of 1
Question on Sealing Tail Lights
by Dean_A » Fri Aug 29, 2008 1:12 pm
OK, I'm about to the point of installing my surface-mount tail lights on the hatch and I have a quick question. Would it be best to seal these tail lights all the way around the exterior of the bezel, or just around the wire hole and the screws?
My gut says that just sealing up the wire hole and putting sealant on the screw threads should be enough, but I want to run it by you all first.
My gut says that just sealing up the wire hole and putting sealant on the screw threads should be enough, but I want to run it by you all first.
-
Dean_A - Gold Donating Member
- Posts: 597
- Images: 55
- Joined: Sat Oct 21, 2006 5:24 pm
- Location: San Diego, CA
by madjack » Fri Aug 29, 2008 1:53 pm
...mark and predrill mounting holes...fill with sealant...put a LARGE glob(tech term) of sealant on/around/in/over/under/thru wires where they come out of light and more around wire entry hole on hatch and screw holes on light...put in place and fasten...in others words...YES...you are on the right track 
madjack
madjack
...I have come to believe that, conflict resolution, through violence, is never acceptable.....................mj
-
madjack - Site Admin
- Posts: 15128
- Images: 177
- Joined: Thu Dec 02, 2004 5:27 pm
- Location: Central Louisiana
