Catrinka,
Here is a shot of my setup for the fuse panel and just above it is a ground bus bar. Do not let the wire colors confuse you. I am using two different size wires and they are speaker wires, so some do not have two seperate colored wires (they are both the same, just one has some black dots on it) Just remember that the ground wire goes to the bus bar and the 'hot' wire goes to the fuse panel.
This picture shows a wire stripper (yellow handles), a crimp tool (red handles), a piece of 12gauge speaker wire, and two female spade connectors.
This picture shows the wire stripped and the connector slipped on it
This one shows the connector in the crimp tool and the wire crimped in the connector
Another shot of the connector being crimped onto the wire.
Hope this helps clarify my previous posts.
Kerry