by greg755 » Fri Jan 09, 2009 8:56 pm
This is a pretty large cooler, I hope it fits in the back of the tear...
It is 6 degrees out tonight so I will go out tomorrow and check that out.
It runs quiet and seems to get cold pretty quick. I have only run it on the 110 so far.
I have not tried the Fast Freeze function yet.
The space inside has two baskets. One Large Basket that is about 14"x14"x20" and goes all the way top to bottom.
The other is about 14x10x10 and sits on a shelf over the compressor housing.
These measurements are estimate, will have to measure for sure tomorrow when I can get out side.
Since Mine was a n open box model it does have a small dent, barley
noticeable.
The latches, hinges and handles seem solid, the latches are all metal the handles and hinge's are plastic.
It weighs 57 pounds, because of its size it is a little bulky to move, not to bad, but when it is loaded I will have someone give me a hand.
Setting the temperature was easy.
I wish that they would have put the control panel on the front and the two plug outlets on the back, right now they are both located on the left hand side.
That will be ok for the gauge when I install it on a slide out, but I may get in there and rewire the plug outlets to the back, I will have to see how the cord(s) react when it is in place.
"It is a cruel thought, that, when we feel ourselves standing on the firmest ground in every respect, the cursed arts of our secret enemies, combining with other causes, should effect, by depreciating our money, what the open arms of a powerful enemy could not." --Thomas Jefferson to Richard Henry Lee, 1779. ME 4:298, Papers 2:298