by alloffroad » Sun Jun 21, 2009 11:39 pm
madprinter, you might be on to something. The top rail is 2.5" X 2.5" angle.There are 2 supports in the middle of each side top rail then the 2 end supports. I could hole saw the top in 3 places, 1 at each end and 1 in the moddle tucked into the support so it doesn't become a hang up or snag point. If I cut the hole slightly larger that the pipe I have now and inserted a piece of pipe to match the hole that would be long enough to reach from the top rail to the bed of the trailer then cut a hole in the bed and put a stopper to support the inserted pipe (1" dia.) but not caping the hole to allow for easy clean out of dirt and debris.
angle &pipe angle &pipe angle pipeipe & angle
Lo______Lo________L_________oL