Burke, here is close up of axel moutning.Probally more steel than needed
I looked for the right size peice so I could u bolt to it but couldn't find it.
This way gave me a little flexability when doing alinement.but after clamping,drilling the holes and bolting it was only off 1/32" when pulling a tape from center od axle up to center of the coupler.I also thoght of laying a short pc along the full pc and 45 a brace across for support but after adding it up it would have taken more steel.I'm impressed with how ridged this frame is,picking up one corner lifts the whole trailer with no flex.
[img]http://www.tnttt.com/gallery/image.php?image_id=54032[img][/img]