Johnny.
Hey, Steve!
Ever try to dado a 10 ft piece-O-ply? ...on a small router table?
That was yesterday... today the wife and I went on a spree and bought a gallon of exterior latex, a quart of primer, two bottles of Feed-N-Wax, 12' of tan-colored Sunbrella to tarp the load for travelling (wagon, remember), and some good-quality urethane 3" foam for the mattress...
Then I set about drawing a profile and cleaning up the dados w/ a chisel...
Tomorrow (later today, actually) I'll cut the profile (bottom half of my teardrop profile) then trim 1-3/4" length from the floor, then set the walls and mark the bulkhead dados... then it's rabbeting the front and rear walls, then a dry fit, then GLUE! Then paint... then wiring... then...
I may have pics up after breakfast, before I start work for the day... I'm fading fast at the moment...
