This subject gets 're-hashed' with some regularity & most folks have strong opinions of whether/how to use the EZ-Up type shelters. First one I bought was a 'slant-leg' KwikShade 10x10' (nominal dimensions, actual canopy was 8x8') for around $65 at Academy Sports. It was/is less than satisfactory & has been relegated to use for shade only, around home for short periods. I then purchased (in 2006) an unbranded First-Up online for about $56 including shipping; it worked great for several years & the only reason it ain't being used now is I left it unattended at deer camp during a severe ice storm where it partially collapsed under weight of more'n an inch of ice. At that only 2 sections of the scissor frame bent/broke & 1 leg twisted. Has been stored awaiting another broken frame to cannibalize

. We used it once for 6 days at Sand Draw, WY (you should know that area Slow) with nearly constant winds of 25-35mph with frequent gusts to 50mph. Had the large 'nail' pegs thru the feet, the guy ropes extended & pegged down with 18" pegs made of re-bar, & additional 1/4" guys on the windward side. The wind actually lifted/vibrated the fabric so much during the week that it abraded most of the silvery coating off the underside (still doesn't leak tho

). That's the fabric that was on during the ice storm collapse & it's still usable. Our son gifted us with a red fabric cover that we've used ever since.
I had my first 'disasterous collapse' this past weekend in Missouri. During a severe night time T'Storm a limb was blown off the tree under which we were parked. The limb hit the guy rope (on the windward side naturally) & loosened it enough that the very strong straight-line winds twisted & colllapsed one side of the First-Up, breaking 1 scissor frame member & 1 of the corner diagonal 'rafter' pieces (guess I finally have a use for the parts from the other damaged frame

). Not sure but I think the limb may have actually hit the canopy first & damaged the frame before loosening the guy??
I always leave the fabric on the frame for storage & have never had any pinholes or abrasion other than from the wind gusts referenced above. I always take a couple of extra minutes & 'push' the fabric between the scissor members back into the center of the frame. This also makes it easier to 'fold' the frame fully & get the entire thing back into the bag, even alone.
As for putting the shelter up/down, I've done it alone many times & with help from my wife or another person, also many times. I can do it alone almost as fast as with help using pretty near the same method narrated above by alfink. Don't think it's ever taken me more'n 10 min, usually less.
We have three (two now I guess

) of the First-Up shelters & none of 'em have ever 'pooled' water on the fabric. I think that one reason is we try to make sure the legs are near exactly vertical. I've seen some folks that try to 'stabilize' the shelter by tugging outward a little on the feet. If you look carefully you'll see that may cause a slight depression of the corner diagonal pieces whereas if you push the feet back in to achieve a 'plumb' vertical leg, the corner diagonals will 'bow' upward slightly. That is the case with mine anyway & results in a taut fabric that don't pool. During very high humidity we sometimes experience condensation on the underside of the fabric or on the metal frame but that doesn't happen often enough to even be a bother.
My very first trip with the TD - this was after a 'deluge' in which the slant-leg KwikShade pooled badly
Our typical camp set-up
The First-Up typically covers this much of the TD
This was camp at Sand Draw, WY where we had constant strong winds - The little 'camo' potty shelter actually 'laid down' several times in the winds
My shelter last Sunday morning
