Not the best when it comes to electric...trailer will be a 6x12 vnose..thinking of keeping it simple and CHEAP...
-Two deep cycle batteries mounted on tongue of trailer wired together
-seperate wire going to truck wiring harness to charge battery off of truck alternator when traveling
-another line coming off the batteries and going into the cargo trailer via a small hole drilled through the floor(do most of you go in through the floor or the sidewall?)
-that wire will go to a 12 volt breaker box
-the 12 volt breaker box will feed the light switch (two interior lights and one porch light)..as well as 1 or 2 12 volt receptacles for charging laptop, phones, cameras etc....
That will be the 12 volt system
-Next will be either a 30 amp chord going through the side or bottom of the trailer(again not sure which one would be better) wired to a 30 amp breaker box...or ill mount the actual plug on the sidewall of the trailer and that plug will be wired to the 30 amp box
-that 30 amp box will feed 2 or 3 receptacles..one of them will be 20 amp in order to occasionally run my 5000 btu air conditioner..
-then I will need some sort of charger/inverter to charge the batteries when Im plugged in and also to convert the ac power to dc power in order to run the lights..Not sure which charger/inverter to get or where to get it????I hear I should get a 3 stage charger with a float so I could properly maintain the batteries??any good model that you guys are using??
Does this sound like a good plan?/? any ideas or tips would be greatly appreciated..not too confident when it comes to electric
I wonder how the trailer is prewired from the factory??..I know that the trailer I ordered is coming with 2 12 volt interior lights with a wall switch as well as a porch light with a wall switch (not sure if its gonna be a seperate switch or not..Probably not)