These aren't mine, these are on the re-built Grasshopper that mine was a stand in for until this one was finished. Mine are the same, only fit the original GH fenders. You can see how Jerry beefed up his ride...bigger, wider tires/rims..of course he used bigger timbers when rebuilding it, too, so it's much heavier than my 700 lb hopper.
Teardrops n Tiny Travel Trailersor t n ttt for short (tnttt.com) |
Painting fenders
17 posts
• Page 2 of 2 • 1, 2
by DragonFire » Sat Jan 21, 2012 6:14 pm
Fender guards:
These aren't mine, these are on the re-built Grasshopper that mine was a stand in for until this one was finished. Mine are the same, only fit the original GH fenders. You can see how Jerry beefed up his ride...bigger, wider tires/rims..of course he used bigger timbers when rebuilding it, too, so it's much heavier than my 700 lb hopper.
These aren't mine, these are on the re-built Grasshopper that mine was a stand in for until this one was finished. Mine are the same, only fit the original GH fenders. You can see how Jerry beefed up his ride...bigger, wider tires/rims..of course he used bigger timbers when rebuilding it, too, so it's much heavier than my 700 lb hopper.
'79 Grasshopper
Coleman Keepers 200a Gang
Coleman Keepers 200a Gang
-
DragonFire - Donating Member
- Posts: 1095
- Images: 21
- Joined: Sun Aug 21, 2011 9:22 pm
- Location: Sacramento, CA
by vwbeamer » Sat Jan 21, 2012 7:33 pm
Not what your thinking, would cost a lot for the materials, but plate them yourself with nickel
http://www.youtube.com/watch?v=Q8Xo43sfLgY&feature=related
http://www.youtube.com/watch?v=Q8Xo43sfLgY&feature=related
- vwbeamer
- Teardrop Master
- Posts: 192
- Joined: Fri Dec 18, 2009 8:34 pm
- Location: Macon, Georgia