Thanks Gage and Mike.
I will take photos of axle (original with leaf springs), interior floor (wood) and interior walls (wallpapered) all of which are original-intact. The exterior cabin is %100 aluminum. It was painted white and I re-painted part of it to match my Jeep. The was-is one cabin light.
The original tongue (round-hollow stock) and v-brace broke while traveling through Yukon Territory in 1975. It was repaired with a section of drive shaft until I replaced the front end tongue later.
I will take a picture of the original sink which looks like a vegetable oil can cut in half (circa 30's or 40's) similar to the can shown on this link (only cut in half for sink use).
http://www.hawcreekoutdoors.com/article ... or_two.htm
My philosophy for the 37 years I have owned it was-is to keep as original as possible (replacing only rotten wood, etc.)
The kitchen cabinet facing & drawers are original, but counter-top and kitchenette walls wood interior door wall was replaced (water). Windows, braces, and locks are original. I added the drip guards.
The frame is original as well the exterior undercarriage (wood-tongue/groove). Will photograph.
Huge thanks for more comments if any... Chico Harkrader