I have been thinking of reskinning "the Hydeaway", the top would be easy as it is floating, the sides are glued on with project adhesive. I built it before I found this forum. Is is possible to remove with damaging the plywood (3/4), or sould I just float the new skin over the old? Any thoughts, ideas?
Aaron
Teardrops n Tiny Travel Trailersor t n ttt for short (tnttt.com) |
reskinning tear, removing glued on aluminum
2 posts
• Page 1 of 1
reskinning tear, removing glued on aluminum
by Aaron Coffee » Sun Jun 24, 2012 8:31 pm
If I could shut my brain off, I could save myself alot of time, money and effort.
-
Aaron Coffee - 1000 Club
- Posts: 1003
- Images: 26
- Joined: Thu Jun 30, 2005 4:40 pm
- Location: Elk Point, SD
Re: reskinning tear, removing glued on aluminum
by PaulC » Sun Jun 24, 2012 11:58 pm
Aaron, try a heat gun to make the glue go soft. You should be able to work through slowly.
Cheers
Paul
Cheers
Paul
Time is the only real capital we have. Money you can replace but time you cannot.
-
PaulC - 3rd Teardrop Club
- Posts: 4439
- Images: 36
- Joined: Mon May 24, 2004 7:27 am
- Location: Laura, SouthernFlinders Ranges, South Australia