Deryk asked:
Sharon what was your deciding factor for the hinged roof vs non hinged?
There are a couple factors.
1- It's attached; so, if a wind catches it, I only have to worry about holding down one end; and, if my hands should slip for some reason, causing it to fall, I know where it will land. (I have hold-down straps that I can hook on, to control/protect the loose end in heavy wind; and, while I have used them, I have never found that I really needed them.) Recognize that there is a way to hinge a flat, full lifting roof but you'd have to be willing and able to wrestle the weight.
2- If it is hinged on the one end, you are lifting less weight. (MyAway's roof is not a foamie, not light weight. It weighs 70 pounds. By lifting it from one end, I'm only lifting 35 pounds.) When someone has an operation and has stitches, the doctors often tell them not to lift more than 35 pounds, a good reason to limit your lifting roof weight...just in case.
3. You don't need to stand in the area where the bed is; so, that's where I put the hinge. (Being short, I can stand almost all the way to the hinged area and slouch the rest of the way. A 5'9"<ish> person can stand all the way to the bench sitting area, without slouching.)