I will fully admit I tend to grossly over pack tools to take and not only do they get disorganized in the tool bag but I am sure there are way to many things I really don't need, I think

The month long trip to California this summer came shortly after we got Compass Rose came back from repair/reconstruction after the accident and all of the electrical, solar controller, inverter, battery, battery monitoring wires had to be re done. On top of this I added the gas point and shower point re did the propane tank support and piping. This was completed, more or less, a couple of days before we left and I basically threw a bunch of tools into a soft tool bag and one basket of electrical fuses, wires, adapters, wall warts, bare power pole connectors with a small torch for soldering, shrink wrap tubing, duct tape and a VOM to troubleshoot electrical stuff that did not work. AND a number of things did not

Lesson learned make sure the battery in your VOM is good, or they don't work, I did replace the VOM which did work once I replaced the 9V battery with a new DC clamp meter from Sears recently.
Tools taken that were used, the 100 piece security bit set (I have a couple of security screws and this also has square and star drivers) seven blade trailer connector tester (helped one individual find the problem with his lights were the terrible patch job he did on the trailer plug not the TV wiring which was fine. Wire cutters, used a number of times once to make up a new coax cable so we could hook up the television at the KOA's (the one I had was too short). Open ended wrenches used to tighten leaking gas line fittings. Hose clamps used on the PCV hose in the Subaru that the transmission repair place forgot to put back after also doing some engine work, (synthetic oil stinks distinctively).
A 1/4 socket set and extension substituted for a nut driver set when I had to loosen the propane tank holder. Chanel locks got used a couple of times for trying to tighten the water hose so it would not leak (it did even after replacing gaskets in Nevada), replace the hose fittings with good quality fittings out in California, problem cured.
Use the 1/2 torque wrench to check the lug nuts a couple of times TV and trailer. (had a rear wheel pass me in San Diego from our Baja bug long ago). So what to leave home, nope, I think I will add a pass through wrench set> I do have to find some way to organize this mess
