I have just gotten around to taking pictures of my frame.
The first picture shown below is of the "side mount" attachment of the Rlexiride axle. The bolts used for attachment are 5/8".
The next pictue is of the Flexiride axle spindle. You can also see that I am installing electric brakes.
Next, is a picture of the rear receiver.
Next, is a picture of the right rear leveling jack. I installed 4 leveling jacks in all.
Next is a picture of the steel framing for the drop floor. Notice that I have set back the floor from the central drop to where the bed will be.
Next, is a picture of the right front stabilizer jack.
Next is picture of front jack (folded).
Next is pictue of front jack in down position.
Next is picture of frame looking towards the rear.
Next is picture looking towards front.
Next is picture of frame still on leveling jacks
Next is picture of frame on the ground. The clearance from bottom of drop floor to ground is 9". As I add weight, I expect the clearance to be 8". If it doesn't, I will adjust the Flexiride axle.
Next is picture of frame taken at an angle.
I next plan to start installing the plywood floor.