by Fred Trout » Mon May 11, 2015 10:33 am
An experiment is definitely in order. Gotta check if the screw explodes the foam when fully installed or if it holds worth a fig at all. I was thinking of using them for alignment and holding the wall in place while the glue cures, so only a few would be needed.
Yeah, gotta drill a pilot hole for both the OSB and foam in oneshot for sure to do the assembly & get it lined up. You would need to drive the plastic screw into the foam. Then frantic running around to apply the GG, line up the holes, drive the screws in from the bottom of the OSB to hold it all together. Should be quite a trick, hehe.
Will post back when I try it out.