Finally getting around to building the DC panel. Made a discovery by accident
(was drilling the hole for a different switch,) If you drill a 1 1/2" hole with a
butterfly bit, you only have to chisel out a little from the corners to make
a single rv switch fit nicely in a piece of wood.
![Image](https://i.imgur.com/xt1CPO5.jpg?1)
![Image](https://i.imgur.com/LdBWHZH.jpg?1)
Nothing too special about a crimped on spade, except that It alowed me to put
a little meat on the wire so the connecter (very long ground bar that I cut into little pieces)
would bite on it.
![Image](https://i.imgur.com/5tzmoky.jpg?1)
Cut off the prongs
![Image](https://i.imgur.com/xbGoeIB.jpg?1)
View of wire in connector.
![Image](https://i.imgur.com/Yr7KABD.jpg?1)
Side view of finished board
![Image](https://i.imgur.com/zzJ48Sn.jpg?1)
Front View
![Image](https://i.imgur.com/fSpUPJz.jpg?1)
Back view of early wiring stage. Missing the white wire from the shunt to the ground buss.
![Image](https://i.imgur.com/dsupR9H.jpg?1)
View when you walk in the door. Still need the countertop and tiny sink installed.
I believe I am going to leave the front open like this. All along I have been shooting for
the Captain Nemo/Starwars/SteamPunk type look.
![Image](https://i.imgur.com/RwcKWJI.jpg?1)
Side view
![Image](https://i.imgur.com/ZKKAWHr.jpg?1)