Well it has been a while but I am getting down to the finish stage I am at the point where i need to build my door but I am concerned with how to seal it any one with some pictures or suggestions on what works the best. My door is square so no curves or bends to account for. Oh and if there is a thread already on this if you can point me to the link i would appreciate it...
Russell Ledford...
sealing the door
3 posts
• Page 1 of 1
-
Dayhiker - Teardrop Builder
- Posts: 40
- Joined: Tue Jul 03, 2007 8:36 am
- Location: Greenville South Carolina
by kirkman » Thu Nov 15, 2007 1:49 pm
There is a tread just above yours on this page titled......Sticky: Hurricane Hinge, Hatch, Struts, Seals, Doors START HERE......Try that one! 
"If you think you are too small to make a difference, try sleeping with a mosquito." -- Dalai Lama XIV
-
kirkman - 1000 Club
- Posts: 1270
- Images: 55
- Joined: Sat Mar 19, 2005 11:42 am
- Location: Elmira, NY
