In this post http://www.tnttt.com/viewtopic.php?t=35112 Some members were discussing the possibility of using a computer power supply as a 12vdc converter. Curiosity got the best of me.
Since my with my background I knew that it was feasible I wanted to check it out. I found a few places of reference. One being http://www.instructables.com/id/Convert-an-ATX-Power-Supply-Into-a-Regular-DC-Powe/
I want to have a clean and stable, high quality 12v power supply since I will have a computer and 2 touchscreen monitors in my TD.
I did a conversion this weekend on a power supply I picked up a Freegeek, a local computer recycler for $10. Mind you, this is a older power supply on the low end of quality/price. The insulated binding posts are pretty cheap at Radio Shack. and USE INSULATED ones :-0 The first one I put together lasted long enough for me to plug it in. :-)
It is an Antec rated for 300w 15a on the 12v rail.
So far so good. I pulled out the 12v and 5v rail. I didn't bother with the (orange wires) 3.3v rail since I will not need it and I doubt most Teardrop people will either. If you are modifying something that used 2 standard 1.5v batteries you might want the 3.3v rail to power them.
Wired up and done:
Power on wire grounded out, this can be put through a switch for remote powering on. Green to Ground. This may be different on some power supplies but Green is the standard.
5vdc rail: Red wires... I will use this for a few usb power ports at a few spots in my trailer.
12vdc rail:Yellow wires...
Under about 12a-14a load. Dropping to 11.5vdc. I ran this for about 30 minutes and it was stable at 11.5vdc.
As you can see it is pretty promising. A higher quality power supply may yield a more stable 12v rail.
My only area of concern is the potential for a battery charger/solar panel to feed back on the 12v rail. I couldn't find anything on if a power supply has this type of protection built in. So I would use a correctly rated blocking diode on the output side of any rail you choose to use.