tony.latham wrote:Tom&Shelly wrote:tony.latham wrote:But the biggee was cutting the ceiling shelf from the skeletons. With my other builds, I had used a jigsaw. On this one, I used my plunge base and Rockler's router guide so it had my full attention.
I think it took me four passes per skeleton but they are nice and plumb. I'd choose this method again and it was a good warm-up for when I cut the hatch ends.
Tony
Nice! What is the bit diameter?
Tom
1/4” spiral upcut. The offcuts should be the correct height for the spar blocking now.
T
Sent from my iPad using Tapatalk
So I was wondering if you are planning on 1/4" ceilings, but I'll be you cut the skeleton with an extra 1/8" for the offcuts, right?
Watching your build is as much fun as doing my own, without all the pesky work!
Tom