I am planning on Prefabricating the outside walls, (1/4" inside & outside plywood walls + 3/4" framing) glued with epoxy.
I plan on using 1-1/2" x 1-1/2" x 1/8" angle steel, 1/4" bolts, nuts, & washers, and 1/4" screws to attach the walls to the floor & frame.
Where their is steel frame below, I will use screws through the angle steel.
Where there is 1/2" plywood, I will use bolts, nuts, & washers through the angle steel.
I will use screws to attach the walls to side of frame.
I will use bolts, nuts, & washers to attach walls to angle steel.
Considering my trailer will be near 7 feet high from the ground, and over 12 feet long, does anyone have any concerns with my plan for attaching the walls?
Sorry about the extremely small drawing.